STRIP COLLATED PINS ASM-144 PINS The smooth shank ASM-144 series pins are commonly
used to fasten to concrete or masonry substrates. Hardwood flooring installers use
these pins to attach plywood, OSB underlayment or wood furring strips to concrete.
Siding contractors use these pins to attach fiber cement siding to concrete or masonry
walls. Select 1-3/4" minimum length and plastic collated pins only for the Model
900 tool. See ICC Report NER-405 for design values for attaching James Hardie fiber
cement siding to masonry.
PART NO. LENGTH (IN) COLLATION CASE QTY
ASM-144-0125C 1-1/4 TAPE 7000
ASM-144-0125P 1-1/4 PLASTIC 3750
ASM-144-0150C 1-1/2 TAPE 6000
ASM-144-0150P 1-1/2 PLASTIC 3750
ASM-144-0175C 1-3/4 TAPE 5000
ASM-144-0175P 1-3/4 PLASTIC 3750
ASM-144-0200C 2 TAPE 4000
ASM-144-0200P 2 PLASTIC 2500
ASM-144-0225C 2-1/4 TAPE 4800
ASM-144-0225P 2-1/4 PLASTIC 2500
SHEET COLLATED PINS STEEL FRAMING PINS AKN-100-XXXXHA series pins are designed specially
for the Model 610 tool to attach plywood, oriented strand board (OSB) and fiber cement
siding to cold formed steel from 97mil (12ga) to 27mil (22ga). These pins are finished
with Aericote® 1000 coating which provides ten times the corrosion protection of
electroplated zinc. When driven, the fastener separates completely from the sheet
plastic collation leaving a clean fastening, especially important when face nailing
The 1" long pins can be used for select steel-to-steel applications of up
to two layers of 54mil (16ga).
Refer to ICC Report #4144 for design values for horizontal
diaphragm and shear wall construction. See ICC Report NER-405 for design values for
use with James Hardie fiber cement siding.
Select sizes of similar pins manufactured
from 300 series stainless steel are available. These pins are limited in use to fastening
to maximum 43mil (18ga) steel. Contact us for details
PART NO. LENGTH (inch) PINS PER COIL CASE QTY.
AKN-100-0100HA 1 200 8000
AKN-100-0150HA 1-1/2 200 8000
AKN-100-0200HA 2 200 8000
AKN-100-0250HA 2-1/2 200 6000
STRIP COLLATED PINS AKN-144 PINS The knurled shank AKN-144 pins are supplied collated
for use with the AERICO® 90 or Model 900 tools. These pins are typically used to
fasten plywood, OSB or lumber to steel members ranging in thickness from 68mil (14
ga) to 3/16 thick. See ICC Report No. 4144 for performance data.
Custom sizes and
packaging is available for special requirements. Contact us for more information
about lengths not shown below.